Heat and Fresh Air Controls

Heat and Fresh Air Controls

Removing

• The controls consist of two separable housings. Before removing controls, bring rotary buttons into the following position:

• Heater control to cold

• Blower to 0.

• Air flow direction to footwell.

- Remove the radio.

- If the vehicle does not have radio, remove the trim from the center of the instrument panel.






- Remove the bolts - 2 - (4.2 x 45) and - 3 - (4.2 x 16) and the controls - 1 - from the center console.






- Release the connector - A - by pulling it in direction of arrow - 1 -.

- Press connector release - B - toward the connector - arrow 2 - and disconnect the connector - C -.

- Release the connector - D - and then disconnect it.

• Illustration shows Climatic version. Procedure to release the connectors is the same.

Installing

Install in reverse order of removal. Be sure install the control knobs in the same position they were in when they were removed.