Vehicle Electrical System Control Module (J519), Replace

Vehicle Electrical System Control Module (J519), Replace

The work procedure "replace the vehicle electrical system control module" contains the following scope of work:

• If a new vehicle electrical system control module (J519) is installed, it must be coded online.

• The factory mode in the vehicle electrical system control module (J519) is deactivated.

• All of the remote keys are programmed again.

This procedure can only be performed with the (Vehicle diagnostic tester) in the "guided fault finding" function.

Procedure

- Connect the (Vehicle diagnostic tester).

- Select Guided Fault Finding.

- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

• Body

• Electrical Equipment

• 01 - On Board Diagnostic (OBD) capable systems

• 09 - vehicle electrical system control module

• Vehicle electrical system control module functions

• Replace the vehicle electrical system control module