Headlamp Alignment Control Module: Service and Repair

Headlamp Range Control Module (J745)

The cornering lamp and headlamp range control module is mounted on the tunnel support baseplate between the glove compartment and center console on the passenger side.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the glove compartment.

- Remove the bolts - arrows -.






- Remove the control module. Pay attention to the wires still connected.

- Press the tab - arrow - and move the bracket - 1 - in - direction of arrow 2 -.






- Remove the headlamp range control module.

Installing

Install in reverse order of removal. Note the following:

• Code the new headlamp range/cornering lamp control module after installing it. Refer to => [ Cornering Lamp and Headlamp Range Control Module (J745), Coding ] Testing and Inspection and then perform a basic setting on the headlamp.

- Check headlamp for functions.

- Check the headlamp adjustment and adjust it if necessary.