Post Treatment of Evaporator

Post-Treatment of Evaporator





- Connect battery terminals.
- Replace blower resistor and blower motor as shown for the model variants.
- Reconnect battery ground lead.
- Reset radio code.

Carry out the following the same way for the model variants.

Drying Evaporator





- Set temperature control to max. heat and select max. blower speed with the blower switch.
- Start engine.

Allow engine to run for 2 minutes.
- Stop engine.

Allow spray to cure for 30 minutes.
- Start engine.
- Open car windows.
- Select recirculation, set temperature control to max. heat and select max. blower speed with the blower switch.

Allow engine to run for 10 minutes to permit coating to dry and form protective skin, and to prevent agent from being washed off by condensation.

Reconnect A/C Compressor





- Reconnect A/C compressor by reconnecting the compressor connector to the car cable harness.

Reinstall all other parts removed.





WARRANTY STATEMENT: Claims may be submitted under the New Car Limited Warranty when a manufacturing defect is present using claim type: 01.