Fan Blade - Contacts Radiator Shroud

87volvo03

SECTION GROUP NO.

21 14

DATE OCTOBER 1987

RE:

FAN/FAN SHROUD ASSEMBLY

740/760 B230FT

1987 M/Y ONLY

THIS BULLETIN APPLIES TO THE U.S. AND CANADA
REFERENCE: NONE


Installation of spacers between engine mounts and front axle cross member Mounting of lower section of fan shroud

If the fan contacts the fan shroud causing noise, the shroud mounting needs to be secured. To improve the fan/fan shroud mounting, we also recommend raising the engine mounts slightly using spacers.


REQUIRED PARTS:

Description Part No. Quantity

Spacers 3514110-0 6
Clip 1324190-6 1




SPACERS, INSTALLING

Remove engine splash guard

Loosen engine mounts on front axle cross member

- Unscrew nuts approximately 6 mm (1/4 in.)

NOTE: Do not remove nuts.






Lift engine slightly

Use two side attachments 5033, hook 5115 and cradle assembly 5006.

- Raise engine until engine mount contacts bottom of nuts.



Install spacers (P/N 3514110-0)

- Fit spacers between engine mount and front axle cross member.

Lower engine

Check position of spacers.
- Tighten engine mount nuts to:

15-25 N-m = 11-18 ft.lbs.



FAN SHROUD, SECURING

Fit fan shroud retaining clip.

- Attach clip to lower edge of fan shroud, between shroud and radiator frame. Lower part of frame should be at the same level as radiator frame. Make sure that fan shroud opening is round.
During the New Car Warranty period, claims must be submitted under:

Operation No. Labor Description Time Allowance

218162 Engine mount spacers, install
Fan shroud, secure 0.5 hr.