Engine: Tools and Equipment

Sealing Micro-enclosed Screws

NOTE: Micro-enclosed screws are used where the seal requirements are high. Loose screws are replaced or sealed with new sealing compound. Sealant "HYDRAULIC THREADSEAL" has P/N 11 61 056-5 and sealing must be carried out according to the instructions on the packet.

The screws to be sealed with "HYDRAULIC THREAD SEAL" and their positions are shown below.

NOTE: As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Sealant

"Hydraulic Thread Sealant"







- P/N 11 61 056-5
- Use a brush and/or the packet spout to apply the sealant to the screw.
- Avoid skin contact with the sealant.

Engine Intake Side










Engine Exhaust Side










Rear Of Engine







Location A
Designation Nipple
Number 1
P/N 976040-6

Engine Front







Location A
Designation Coolant pump screw
Number 7
P/N 977744-2