Replacing Pressure Sensor

Replacing pressure sensor

Removing the transmission side cover
See Removing gearbox side cover Removing Gearbox Side Cover.

Disconnecting the pressure sensor





Remove:
- the clip for the cable harness from the pressure sensor
- the connector
- the screws.

Note! The upper screw is M10. The two shiny screws are self tapping.

Disconnect the pressure sensor.
Check that all (6 x) O-rings remain in the pressure sensor.

Installing the pressure sensor




Apply a little automatic transmission fluid on the sensor O-rings.

Install:
- the pressure sensor
- the screws loosely (finger tight).

Note! The upper screw is a M10 screw head. The three long screws are M8. The two shiny short screws are self tapping and should go into the same threads as before.

Tighten the screws lightly crosswise. The tighten to the black screwsto 12 Nm.
Then tighten the two self tapping screws to 8 Nm.

Install:
- the connector
- the clip for the cable harness for the pressure sensor.

Installing the transmission side cover
See Installing the gearbox side cover Installing the Gearbox Side Cover.