Replacing the Trip Computer Switch

Replacing The Trip Computer Switch







- Remove the knobs from the heater control; insert a small screwdriver at the rear edge under each knob.
- Remove the heater control panel (insert two fingers into the opening and carefully pull out the control panel).
- Remove the four torx mounting screws.
- Remove the rear section of the bracket. Carefully press the edge with a screwdriver.

NOTE: The radio must be pulled forward a few centimeters before the rear section of the bracket can be removed.

- Remove the screws behind the rear section of the bracket. Pull the bracket forward slightly.
- Press in the retaining clips on the reverse of the trip computer switch.

Reinstall the components in reverse order.