Signal Too Low / High or Signal Missing
Signal too low / high or signal missing
Checking components and wiring
Check the signal cable (speed). Check between accessory control module terminal #B14 and the connector for the radio. Check for a short-circuit to ground. Check for a short-circuit to supply voltage. Check for an open-circuit.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box. Accessory electronic module Connecting the Breakout Box, Accessory Electronic Module (AEM)
- To access or replace the accessory electronic module and connector, see Replacing the accessory electronic module, B5244T5, B5254T2 Accessory Electronic Module (AEM)
- For information about signals, see Signal description. Accessory electronic module (AEM) Signal Description, Accessory Electronic Module (AEM)
- To fault-trace wiring and terminals see Checking wiring and terminals Checking Wiring And Terminals
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reconnect the components, connectors etc.
- Ignition on.
Check the speed function by clicking on the VCT2000 symbol while the radio is on.
Does the system function?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking components and wiring
-------------------------------------------------