Not Connected or Communication Problems. Permanent Fault
Not connected or communication problems. Permanent fault
Checking for contact resistance and oxidation
Check the amplifier and head unit / audio control module connectors for contact resistance and oxidation according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Remedy if necessary.
Other information:
- Radio equipment, replacing Radio Equipment, Replacing
- Radio/telephone, changing Service and Repair
- Connecting the breakout box, Audio control module Connecting the Breakout Box, Audio Control Module
- Signal specification, audio control module Signal Specification
If the sound reproduction is now OK, the fault was due to a bad connection in the connectors.
Is sound reproduction OK?
Yes - Fault Found
No - Checking the wiring and component
-------------------------------------------------
Checking the wiring and component
Check the cable between the amplifier terminal #D6 and head unit terminal #D6 for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.
Other information:
- Radio equipment, replacing Radio Equipment, Replacing
- Radio/telephone, changing Service and Repair
- Connecting the breakout box, Audio control module Connecting the Breakout Box, Audio Control Module
- Signal specification, audio control module Signal Specification
Select "Continue" when the fault has been remedied.
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off.
- Reinstall connectors, components etc.
- Ignition on.
Check that sound reproduction is OK.
Is sound reproduction OK?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking for contact resistance and oxidation
-------------------------------------------------