Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Intermittent fault




- Ignition off.
Check the signal cable between the central electronic module (CEM) and the immobilizer antenna unit.
Diagnostic trouble code (DTC) CEM-6C41:
The cable between the central electronic module (CEM) terminal #14D and the immobilizer antenna unit terminal #2
Diagnostic trouble code (DTC) CEM-6C43:
The cable between the central electronic module (CEM) terminal #13D and the immobilizer antenna unit terminal #3.
Check signal cable for supply voltage.
Remedy as necessary.

Other information:
- To access the central electronic module (CEM) connector, see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- To access the immobilizer antenna unit/connector, see Antenna unit immobilizer, replacing Service and Repair
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- For information about signals, see Signal specification Pinout Values and Diagnostic Parameters
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Intermittent fault

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------