Faulty Signal

Faulty signal

Checking for permanent or intermittent faults
Operate the window to its limit positions.
DDM-003B: Driver's window
DDM-003C: Passenger window
DDM-003D: Left rear side window
DDM-003E: Right rear side window

Is the power window control operating correctly?

Yes - Intermittent fault

No - Checking the operation of the window

-------------------------------------------------

Checking the operation of the window
Check that the button for operating the window is in the correct position. Check that the button has not jammed in an incorrect position. Press the button a few times and try to run the window up and down.

Is the power window control operating correctly?

Yes - Intermittent fault

No - Replacing the component

-------------------------------------------------

Replacing the component




- Ignition off.
The driver door module (DDM) has registered an internal fault.

Note! A new control module is delivered without software. The control module must be programmed when it has been replaced.

Other information:
- For further information about programming and replacing the control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver's Door Module/Passenger Door Module (DDM/PDM), Replacing.
After replacing the control module the window position must be initialized.
Ignition on.
Move the window to its upper limit position using manual control.
Initialize the window.
From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization.






Continue - Fault Found

-------------------------------------------------

Intermittent fault




Fault-tracing information

Fault-tracing information
Fault-tracing indicates that the control module had previously identified an intermittent fault, but that the fault is no longer present.


Continue - DONE

------------------------

DONE - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking for permanent or intermittent faults

-------------------------------------------------