Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking the wiring
Check the power supply cable between rear electronic module connector #B20 (#D20) and tilt sensor connector terminal #1 for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.

Other information
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters.
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box.
- To access the rear electronic module, see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
Open the boot lid and lock in the open position by pressing in the lock hinge.
Lock the car by remote control.
Wait for 25 seconds until the alarm is activated and sound the alarm by releasing the level sensor and turning it.

Is function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------