Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wiring and connections
Check the wires between steering wheel angle sensor (SAS) control unit #3 (#A27) and steering wheel control unit (SWM) #5 (#A5) for a short circuit to voltage supply, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Additional information:
- To connect the test box to the steering wheel angle sensor control unit, see Connecting the breakout box to the steering angle sensor Connecting the Breakout Box, Steering Wheel Angle Sensor Module (SAS).
- To connect the test box to the steering wheel control unit, see Connecting the breakout box Connecting the Breakout Box, Steering Wheel Module (SWM).
- For information on signals to the steering wheel angle sensor control unit, see Signal description, Control unit for the steering wheel angle sensor (SAS) Signal Specification.
- For information on signals to the steering wheel control unit, see Signal specification Signal Specification, Steering Wheel Module (SWM).










Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the wiring and connections

FAULT FOUND - Fault Found

-------------------------------------------------