Configuration Fault

Configuration fault. Permanent fault

Checking the component




- Ignition off.
Check the control module and SRS system connectors to ensure that no terminal pins are damaged. Also check the wiring.
Check that the correct SRS control module is installed in the car. Read off by clicking the VCT2000 symbol.
Replace the control module if no fault is found.

Other information:
- To access or replace the control module, see Control module SRS (supplemental restraint system), replacing Service and Repair
- For other values, see Signal specification Signal Specification, Supplemental Restraint System Module (SRS).









Select "Continue".

Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the component

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------