Resistance Too High
Resistance too high. Intermittent fault
Intermittent fault
- Ignition off.
Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical seat belt tensioner. This could deploy the seat belt tensioner!
Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.
Check the connectors for the SRS module and seat belt tensioner. Check for contact resistance and oxidation. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for loose connections. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the female and male parts of the connectors for the SRS control module and the seat belt tensioner. The cable terminals must not be damaged or pressed back.
Caution! For V70 2000- with model year 2000 and 2001:- If diagnostic trouble code (DTC) SRS-0084 for the right seat belt tensioner is registered, follow fault-tracing for the center seat belt tensioner (SRS-007C).- If diagnostic trouble code (DTC) SRS-007C for the center seat belt tensioner is registered, follow fault-tracing for the right seat belt tensioner (SRS-0084).
Check the cable between the SRS control module and the terminal on the seat belt tensioner connector according to the following:
for diagnostic trouble code (DTC) SRS-0064,
terminals #5A(5), #6A(6) of the front left seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-006C,
terminals #5C(1), #6C(2) of the front right seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-0074,
terminals #16A(16), #15A(15) of the rear left seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-007C,
terminals #17A(17), #18A(18) of the center rear seat belt tensioner and connector terminals #1, #3.
for diagnostic trouble code (DTC) SRS-0084,
terminals #16C(12), #15C(11) of the rear right seat belt tensioner and connector terminals #1, #3.
for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.
Other information:
- To access and replace the Supplemental Restraint System Module (SRS) and connector, see Control module SRS (supplemental restraint system), replacing Service and Repair
- To replace the seat belt tensioner, see Seat belts, replacing Seat Belts, Replacing
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- With the ignition off and the seat belt tensioner connector disconnected, the resistance between the seat belt tensioner connector terminals #1 and #3 (SRS control module side) must be approximately 22 kohms.
- For information about the repair of SRS wiring, see Cable harness SRS system, repair Procedures
- For other values, see Signal specification Signal Specification, Supplemental Restraint System Module (SRS).
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Intermittent fault
FAULT FOUND - DONE
-------------------------------------------------