Cable Fault

Cable fault. Intermittent fault

Intermittent fault




- Ignition off.

Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.

Check the connectors for the SRS control module and the side impact sensor. Check for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between the SRS control module and the terminal on the side impact sensor connector according to the following:

for diagnostic trouble code (DTC) SRS-00B0,
front left side impact sensor terminals #8A (8) and #9A (9) and connector terminals #1 and #2.

for diagnostic trouble code (DTC) SRS-00B5,
front right side impact sensor terminals #8C (4) and #9C (5) and connector terminals #1 and #2.

for diagnostic trouble code (DTC) SRS-00BA,
rear left side impact sensor terminals #27A (27) and #28A (28) and connector terminals #1 and #2.

for diagnostic trouble code (DTC) SRS-00BF,
rear right side impact sensor terminals #27C (23) and #28C (24) and connector terminals #1 and #2.
check for an intermittent short-circuit to supply voltage. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check for an intermittent short-circuit to ground. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To access and replace the SRS control module and the connector, see Control module SRS (supplemental restraint system), replacing Service and Repair
- To access or replace the side impact sensor, see Collision sensor B and C-post, replacing Service and Repair
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- For other values, see Signal specification Signal Specification, Supplemental Restraint System Module (SRS).










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Intermittent fault

FAULT FOUND - DONE

-------------------------------------------------