Signal Missing

Signal missing

Checking the wiring








- Ignition off
- Disconnect central electronic module (CEM) connector D.
The Diagnostic Trouble Code (DTC) indicates that the communication between the Central Electronic Module (CEM) and cruise control switch is not working.
This may be due to a fault in the signal cable between the control modules or a damaged communication device in one or all of the control modules.
Check the connectors for loose connections, damaged or bent terminal pins and oxidation.
Check the signal cable. Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- The Central Electronic Module (CEM) #D58 (#58) and cruise control switch #2.
Also check the intermediate connectors.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Pinout Values and Diagnostic Parameters
- Location of components Locations
- Keypad unit, steering wheel, replacing Keypad Unit, Steering Wheel, Replacing
- Steering wheel module (SWM), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals

Was a fault detected?

Yes - Verification

No - Replacing the control module

-------------------------------------------------

Replacing the control module
Try a new cruise control switch.
Remedy as necessary.

Other information
- Keypad unit, steering wheel, replacing Keypad Unit, Steering Wheel, Replacing


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the function for the relevant button or switch is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking the wiring

-------------------------------------------------