Internal Fault

Internal fault

Replacing the component

Note! The diagnostic trouble code (DTC) may be stored as a consequence of other faults. Check therefore if any other diagnostic trouble codes (DTCs) are stored for the engine control module (ECM). Remedy these first.

The engine control module (ECM) has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the engine control module (ECM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs.
Engine control module (ECM), replacing Service and Repair
Remedy as necessary.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------