Internal Fault

Internal fault

Replacing and programming the SRS control module




The SRS control module has registered an internal fault.

Caution! A new SRS control module is delivered without software. The control module must be programmed in order to function after replacement.

For further information about programming and replacing the SRS control module, see Control module SRS (supplemental restraint system), replacing Service and Repair.


Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Replacing and programming the SRS control module

FAULT FOUND - Fault Found

-------------------------------------------------