Signal Missing

Signal missing

Checking the component and wiring








- Switch off the ignition. Wait 10 seconds
- Disconnect the 10-pin connector from the occupant weight sensor (OWS) module
- Disconnect the connector from the seat belt force sensor.

Caution! Avoid touching the terminal pins in the occupant weight sensor (OWS). There is a risk of static discharge which could damage the occupant weight sensor (OWS).

Check the connectors for the seat belt force sensor and the occupant weight sensor (OWS) module. Check for damage to pins and terminals in the connectors.
Remedy as necessary.
Check the wiring between the occupant weight sensor (OWS) module and the seat belt force sensor. Check for an open-circuit.
Remedy as necessary.
If no malfunction is found: Replace the seat belt force limiter.

Other information
- For further information about cable routing and terminals, see the wiring diagram
- Signal specification Signal Specification, Occupant Weight Sensor (OWS)
- For replacement of seatbelt force sensor: Force limiter mechanical/belt tension sensor, replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals





Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component and wiring

-------------------------------------------------