Signal Too Low

Signal too low

Checking components and wiring




- Ignition off.
Check the connectors for the Suspension Module (SUM) and the position sensor. Check for contact resistance and oxidation.

For diagnostic trouble code (DTC) SUM-0031, rear left position sensor:
- Check the signal cable between control module terminal #A28 and position sensor terminal #4. Check for a short-circuit to ground
- Check the cable for power supply between control module terminal #A25 and position sensor terminal #5. Check for an open-circuit. Check for a short-circuit to ground.

For diagnostic trouble code (DTC) SUM-0041, rear right position sensor:
- Check the signal cable between control module terminal #A14 and position sensor terminal #4. Check for a short-circuit to ground
- Check the cable for power supply between control module terminal #A13 and position sensor terminal #5. Check for an open-circuit. Check for a short-circuit to ground.

Hint: Click on the VCT2000 symbol to check the signal from the position sensors.

Try a new position sensor if no fault is found in the wiring.
Remedy as necessary.

Other information:
- To access or replace the position sensor, see Position sensor suspension rear (Four-C), replacing Service and Repair
- For information about components, see Component specifications [1][2]Specifications
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Suspension Module (SUM)
- For information about signals, see Signal specification Signal Specification, Suspension Module (SUM)
- Checking wiring and terminals Checking Wiring And Terminals.














Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check the signal from the position sensor by clicking on the VCT2000 symbol. The value varies between 0.5-4.5 V depending on the degree of lean of the car.





Is the value OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking components and wiring

-------------------------------------------------