Signal Too Low

Signal too low

Checking components and wiring




- Ignition off.
Check the connectors for the Suspension Module (SUM) and the keypad. Check for contact resistance and oxidation.

For diagnostic trouble code (DTC) SUM-0151, keypad:
- Check the signal cable between control module terminal #A24 and keypad terminal #1. Check for a short-circuit to ground.
Try a new keypad if no fault is found in the wiring.
Remedy as necessary.

Other information:
- For information about components, see Component specifications [1][2]Specifications
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Suspension Module (SUM)
- For information about signals, see Signal specification Signal Specification, Suspension Module (SUM)
- Checking wiring and terminals Checking Wiring And Terminals.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking components and wiring

FAULT FOUND - DONE

-------------------------------------------------