Signal Too High

Signal too high

Checking for permanent or intermittent faults




- Ignition on
- Operate the sun roof to full tilt.
Check that the automatic operation of the sun roof works.

Was the function OK?

Yes - Verification

No - Replacing the component

-------------------------------------------------

Replacing the component








- Replace the sun roof motor. See Electric motor, sun roof, replacing Service and Repair
- Ignition off
- Reinstall the components, reconnect the connectors etc.
- Ignition on.
Check that the automatic closing of the sun roof works.

Does the automatic closing of the sun roof work?

Yes - Verification

No - Replacing the component

-------------------------------------------------

Replacing the component
Replace the sun roof control module according to Sun roof module (SRM), replacing Service and Repair.


Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Check that the automatic sunroof closing works.

Does it work?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------