Fuel Pressure Sensor: Service and Repair

Fuel pressure sensor, replacement

Removal and Installation

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparation




Drain the fuel injection system. See Fuel system pressure release .
Remove the charge air pipe over the engine. Seal the openings.
Remove the cover over the fuel rail.

Removing the fuel pressure sensor





Caution! Collect any spill using paper or similar.

Remove:
- the tie strap for the cable for the sensor
- the screw for the sensor
- the sensor.

Installing the fuel pressure sensor

Note! For tightening torques, see Tightening torque Tightening Torque.

Install:
- the sensor
- the screw for the sensor. Tighten
- the tie strap for the wiring. Connect the cable to the sensor
- the cover over the fuel rail.




Remove the seals from the charge air pipe. Reinstall the charge air pipe over the engine.
Start the engine. Check for fuel leakage.