Fault-Tracing Information
Fault-tracing
Checking the wiring and terminals
Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnically inflatable curtain. This could deploy the inflatable curtain!
- Ignition off, wait for 15 seconds.
- Disconnect the connector for Supplemental restraint system module (SRS).
- Disconnect the connector from the left-hand inflatable curtain.
Hint: Check if other diagnostic trouble codes (DTCs), that indicate another activatable collision protection system, are stored.
The fault is due to a short-circuit to another circuit in the activatable collision protection system.
Check connectors for damage to pins and connections.
Also check other connectors and terminals that connect the wiring between the Supplemental restraint system module (SRS) and the inflatable curtain.
Note! The connector to the activatable collision protection system in the other circuit must be disconnected before a reading is taken.
Check the cable. Check for a short-circuit to another circuit with activatable collision protection system. The resistance reading should read infinite resistance.
Take readings between:
- The connector to the left-hand inflatable curtain terminal #1 and the connector to the other activatable collision protection system terminals #1 and #2.
- The connector to the left-hand inflatable curtain terminal #2 and the connector to the other activatable collision protection system terminals #1 and #2.
Remedy as necessary.
Other information
- Connecting the breakout box Connecting The Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification Signal Specification, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.
- Inflatable curtain Inflatable Curtain
- Cable harness SRS system, repair Cable Harness SRS System, Repair
- Checking wiring and terminals Checking Wiring And Terminals
Continue - Powering the SRS system
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the wiring and terminals
-------------------------------------------------
Powering the SRS system
Powering the SRS system
Powering the SRS system
Warning! Nobody should be in the passenger compartment when the SRS (supplemental restraint system) is first powered after fault-tracing/repair.
Caution! Ignition off during the entire procedure.
- Reinstall the connectors, components etc.
- If the battery negative lead has been removed: Connect the battery negative lead.
When powering up the SRS-system, other systems and components in the vehicle will also be activated.
Power the SRS (supplemental restraint system) by clicking the VCT2000 symbol.
Performing the service may take up to 15 seconds.
Continue - FAULT FOUND
------------------------
FAULT FOUND - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair check that the fault has been remedied.
- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.
Is the fault intermittent?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFICATION FAILED - Fault-tracing information
VERIFIED - VERIFIED
-------------------------------------------------