Fault-Tracing Information

Fault-tracing

Checking the wiring and terminals








- Ignition off, wait for 15 seconds.
The supplemental restraint system module (SRS) detects that the rear right-hand seat belt buckle is connected to the control module.
The right-hand rear seat belt buckle must not be connected to the supplemental restraint system module (SRS).
- Remove the connector/component.
Remedy as necessary.

Other information
- Signal specification Signal Specification, Supplemental Restraint System Module (SRS)
- For further information, see the wiring diagram.
- Safety belt buckle, rear Safety Belt Buckle, Rear

Continue - Powering the SRS system

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring and terminals

-------------------------------------------------

Powering the SRS system




Powering the SRS system

Powering the SRS system

Warning! Nobody should be in the passenger compartment when the SRS (supplemental restraint system) is first powered after fault-tracing/repair.

Caution! Ignition off during the entire procedure.








- Reinstall the connectors, components etc.
- If the battery negative lead has been removed: Connect the battery negative lead.
When powering up the SRS-system, other systems and components in the vehicle will also be activated.
Power the SRS (supplemental restraint system) by clicking the VCT2000 symbol.
Performing the service may take up to 15 seconds.





Continue - FAULT FOUND

------------------------

FAULT FOUND - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Switch on the ignition. Wait 10 seconds.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - VERIFIED

-------------------------------------------------