Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-P022200

Condition




The engine control module (ECM) checks the signals from position sensor in the throttle unit.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Signal from any of the sensors is unreasonably low.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- In case a defective signal is detected, the other signal is used.
- Cruise control turned off when malfunction is active.

Possible source
- Contact resistance or oxidation in the terminals
- Signal cables short-circuited to ground.
- Open circuit on signal cables.
- Voltage feed short-circuited to ground.
- Open circuit on voltage feed.
- Damaged electronic throttle unit.

Fault symptom[s]
- Driving/Poor performance/lacks power/At take off
- Driving/Poor performance/lacks power
- Driving/Hesitates/surges/Unsure when/at all times
- Driving/Hesitates/surges/During acceleration
- Driving/Hesitates/surges/During deceleration
- Cruise control/Does not engage
- Driving/Hesitates/surges/At steady speed