Signal Too Low Or Signal Missing

Signal too low or signal missing

Checking components and wiring
Check the signal cable for alarm output P1. Check between accessory control module terminal #B16 and the alarm unit connector. Check for a short-circuit to ground. Check for an open-circuit.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box. Accessory electronic module Connecting The Breakout Box, Accessory Electronic Module (AEM)
- To access or replace the Accessory Electronic Module (AEM) and connector, see Accessory electronic module (AEM), replacing Replacing Accessory Electronic Module
- For information about signals, see Signal description. Accessory electronic module (AEM) Signal Description, Accessory Electronic Module (AEM)
- To fault-trace wiring and terminals see Checking wiring and terminals Checking Wiring And Terminals









Continue - Verification

-------------------------------------------------

Verification





Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the components, connectors etc.
- Ignition on.
Check the function of the alarm by activating it appropriately.

Does the system function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------