Signal Missing

Signal missing

Checking the component and wiring








- Ignition off
- Disconnect the connector for the center loudspeaker.
Check the cable terminals. Check for contact resistance, loose connections and oxidation.

Note! Only visually check the treble loudspeaker. Check for oxidation and loose connections. Do not carry out any electrical fault-tracing on the treble loudspeaker.

Check the cable terminals in the female and male sections of the connector. The cable terminals must not be damaged or pressed back.
Check the signal cable between audio module (AUD) terminal #B10 and center loudspeaker terminal #1. Check for an open-circuit.
Check the signal cable between audio module (AUD) terminal #B2 and center loudspeaker terminal #2. Check for an open-circuit.

Hint: Check the connector between the Audio module (AUD) and the center loudspeaker. Check for contact resistance, play and oxidation.

Check the center loudspeaker connector terminals #1 and 2. Check for an open-circuit.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Audio Module (AUD)
- Audio module (AUD), replacing Audio Module (AUD), Replacing
- Central loudspeaker, replacing Centre Loudspeaker
- Signal specification Signal Specification, Audio Module (AUD)
- Checking wiring and terminals Checking Wiring And Terminals





Continue - Verification

-------------------------------------------------

Verification





Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the sound is heard from speaker for Audio module (AUD) by trying the radio FM/AM or the cd-player.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------