Signal Too High

Signal too high

Replacing the component
The central electronic module (CEM) has registered an internal fault in the light switch module (LSM).
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the central electronic module (CEM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the fault recurs, replace the light switch module (LSM).
Switches lights, replacing Switches Lights, Replacing
Remedy as necessary.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------