Faulty Signal

Faulty signal

Checking for permanent or intermittent faults




- Ignition on.
Operate each function and check the function.

Are the controls working?

Yes - Intermittent fault

No - Replacing the component

-------------------------------------------------

Replacing the component




- Ignition off.
The control module has registered an internal fault.

Note! A new control module is delivered without software. The control module must be programmed when it has been replaced.

Other information:
- For further information about programming and replacing the control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver Door Module (DDM).
After replacing the control module the window position must be initialized.
Ignition on.
Move the window to its upper limit position using manual control.
Initialize the window.
During initialization, the window will automatically go down to its lowest position and then go back up again.





Continue - FAULT FOUND

-------------------------------------------------

Intermittent fault





Fault-tracing information

Fault-tracing information
Fault-tracing indicates that the control module had previously identified an intermittent fault, but that the fault is no longer present.

Continue - DONE

------------------------

DONE - Fault-tracing information

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking for permanent or intermittent faults

-------------------------------------------------