Signal Too Low

Signal too low

Checking components and wiring
Check signal cable M1 between door control module connector terminal #B2 and central locking motor connector terminal #8. Check for a short-circuit to ground.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box Connecting The Breakout Box, Driver Door Module (DDM) / Passenger Door Module (PDM)
- To access and replace the door control module, see Driver's door module / passenger door module (DDM/PDM), replacing Driver Door Module (DDM)
- For information about signals, see Signal specification Signal Specification, Driver Door Module (DDM) / Passenger Door Module (PDM)
- Checking wiring and terminals Checking Wiring And Terminals.

Continue - Verification

-------------------------------------------------

Verification





Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the central locking system functions.

Does the central locking system function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------