Capacitance Too Low

Capacitance too low

Checking the cable








Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical seat belt tensioner. This could deploy the seat belt tensioner!

The probable cause of this fault is that the terminal nearest the left seat belt tensioner on the 3rd seat row is defective. Try replacing the wiring for the seat belt tensioner.
Remedy as necessary.

Other information:
- To access and replace the seat belt tensioner, see Seat belts, replacing Service and Repair
- For information about the repair of SRS wiring, see Cable harness SRS system, repair Procedures.

Continue - Verification

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the cable

-------------------------------------------------

Verification





Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------