Fault-Tracing Information

Fault-tracing

Fault-tracing information
Use the following information and general checks during fault-tracing.

Note! Check that the fuses are intact. For locations, see the instruction manual, cover for fuse box, fuse ratings or similar.

1. Check, if possible, relevant functions in the vehicle using buttons/controls/test drives to determine the status of the fault.

Note! If the vehicle does not show any of the given symptoms in the diagnostic trouble code information (DTC), this may mean that the fault is intermittent or that the control module is not detecting the fault at this moment.

2. Use the diagnostic trouble code's frozen values, status identifiers and counter to determine the operating conditions when the fault was detected, the fault's current status and any degree of intermittence of the fault.
3. Check and fault-trace according to the fault causes that are specified in the diagnostic trouble code (DTC) information.
4. Use VIDA Vehicle communication. Read off the parameters, activate components and functions, carry out quick tests and checking routines for the diagnostic trouble codes to identify the fault.
5. Check relevant components according to Component specifications.
6. Check relevant signals using wiring diagram, signal specification and breakout box.

Note! More information is available in Design and function.

Remedy as necessary.

Other information
- Description of status identifier Description Of Status Identifier
- Description of counter Description Of Counter
- Description of parameters , B6324S5 Description Of Parameters
- Description of activations, B6324S5 Description Of Activations
- Location of components, B6324S5 Locations
- Component specifications, B6324S5 [1][2]Computers and Control Systems
- Connecting the breakout box, B6324S5 Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification, engine control module (ECM), B6324S5 Signal Specification, Engine Control Module (ECM)
- Checking wiring and terminals Checking Wiring And Terminals













Continue - Fault-tracing information

-------------------------------------------------






Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------