Center Console Removal/Installation

Center Console Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the center console, the dashboard, or the related parts.

1. Pull up the A/T gear position indicator cover (A) to release the hooks (B).






2. Remove the driver's console trim (A) and the passenger's console trim (B).

1. Pull up on the rear portion of the trim by hand to detach the clips (C).

2. Pull up the trim by hand to detach the clips (D) from the dashboard, then remove it.





3. Open the armrest (A), then pull up the center console panel (B) to detach the clips.






4. Remove the screw (A) and the clip (B), then pull out the driver's console cover (C) to detach the clips (D), and release the hook (E). Release the fastener (F) and the hooks (G), then remove the cover.






5. Pull out the passenger's console cover (A) to detach the clips and release the hooks (B) and pull it backward to release the pin (C) from the passenger's dashboard undercover, then remove it.






6. Remove the center console (A):

1. Disconnect the console accessory power socket connector (B), the console light bulb socket (C), and the USB sub cord harness connector (D).

2. Remove the bolts (E) of the console.

3. Lift the rear of the console, then detach the clips (F) by pulling the console backward to remove it.





7. Install the center console in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.
- Make sure each connector is plugged in properly.