Removal and Replacement

Battery Removal and Installation

NOTE: The battery terminal disconnection/reconnection procedure Procedures must be done before and after doing this procedure. Some systems store data in memory that is lost when the battery is disconnected.

Removal

1. Do the battery terminal disconnection procedure.

2. Remove the two nuts (A) securing the battery hold down plate, then remove the battery setting plate (B) and the battery (C).






Installation

1. Install the battery (A), then install the battery hold down plate (B).





2. Tighten the two nuts (C) equally until the battery is stable.

NOTE: Do not deform the battery hold down plate by over-tightening the nuts.

3. Do the battery terminal reconnection procedure.

NOTE: Make sure the battery is installed correctly, and the positive and negative terminals are not reverse connected.