Audio-Navigation Switch Panel Removal/Installation (With ELS Audio System)

Audio-Navigation Switch Panel Removal/Installation

With ELS Audio System

NOTE:

- Put on gloves to protect your hands.

- Take care not to scratch the dashboard and related parts.

- Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.

- Do not work in a dusty or dirty place.

- Discharge static electricity from your body before and during the work.

- Do not work with dirty hands.

- Do not touch the circuit board with your bare hands.

- Be careful not to fold the flat plate cable.

- Do not touch the terminal connector of the flat plate cable with your bare hands. (If you have touched it, wipe it off thoroughly.)

1. Remove the driver's center trim Dashboard Center Trim Removal/Installation and passenger's dashboard trim. Passenger's Dashboard Trim Removal/Installation

2. Remove the passenger's center trim. Dashboard Center Trim Removal/Installation

3. Remove the climate control unit. Climate Control Unit Removal/Installation

4. Pull out the audio-navigation switch panel (A).

5. Disconnect the connectors (B), and remove the audio-navigation switch panel.

6. Remove the dashboard center vent. Dashboard Center Vent Removal/Installation






7. Remove the interface dial Service and Repair and hazard warning switch Service and Repair from the audio-navigation switch panel (A).

8. Install the audio-navigation switch panel in the reverse order of removal.