Front Bumper Removal / Installation

Front Bumper Removal/Installation

Special Tools Required

- Push Push Pin Puller 07AAC-SJAA100

NOTE:

- Use the special tool to remove the clips.
- Have an assistant help you when removing and installing the front bumper.
- Take care not to scratch the front bumper or the body.
- Put on gloves to protect your hands.

1. Remove these items:

- Front air spoiler Front Air Spoiler Replacement
- Upper grille cover Upper Grille Cover Replacement

2. Remove the bolts (A, B, C), the screws (D), and the clips (E) securing the front bumper (F).






3. Pull out the front bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacers (C).






4. With the help of an assistant, pull both side of the front bumper (A) away from the side spacer (B). Then pull out the front bumper to release the hooks (C) on the corner upper beam (D).






5. Disconnect the front fog light connectors (A), the outside temperature sensor connector (B), and the headlight washer tube (C), then remove the front bumper (D).






6. If necessary, release the hooks, then remove the front bumper absorber (A).





7. Install the bumper in the reverse order of removal, and note these items:

- Make sure each connector is plugged in properly, and the headlight washer tube is connected properly.
- Make sure the front bumper engages the hooks (of both corner upper beams and side spacers) on each side securely.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.