Removal and Replacement

Throttle Body Removal/Installation

CAUTION
Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.

NOTE: If you are replacing the throttle body, begin at step 1. If you are removing the throttle body temporarily, begin at step 4.

1. Connect the HDS while the engine is stopped.

2. Select the INSPECTION MENU with the HDS.

3. Do the TP POSITION CHECK in the ETCS TEST.

4. Turn the ignition switch to LOCK (0).

5. Disconnect the MAP sensor connector (A) and the throttle body connector (B).





6. Loosen the hose band, then remove the intake air duct (C).

7. Disconnect and plug the water bypass hoses (D).

8. Remove the throttle body (E).

9. Install the parts in the reverse order of removal with a new gasket (F), then do this:

NOTE:

- When tightening the screw of the hose clamp (G), align the edge of the hose clamp (H) with the painted mark (I).
- Refill the radiator with engine coolant Service and Repair.

10. Do the PCM idle learn procedure PCM Idle Learn Procedure.