Leak Detection Pump: Service and Repair

Leak Detection Pump (LDP) -V144, Removing and Installing

Removing
- Remove left rear wheel.
- Remove left rear wheel housing liner.







- Cut tie wrap -1- and remove hose -2-.
- Disconnect hose coupling -3- after pressing tab.
- Remove nuts -arrows-.
- Switch off ignition.
- Remove LDP, unclip and disconnect connector.


Installing
Installation is in reverse order of removal, but do the following:


NOTE: Secure all hoses with clamps that are the same as factory installed.


CAUTION!
Always refer to the latest parts catalog to ensure that you use original equipment fuel hose clamps.







- Secure hose -2- with tie wrap -1- to bracket of LDP.

Tightening torque:
Component Nm
Bracket for Leak Detection Pump(LDP) 7.5