Tunnel Crossmember

Tunnel Crossmember

Special tools, testers and auxiliary items required

• Engine-/Gearbox Jack (V.A.G 1383 A)

• Gearbox Support (T10337)

Removing






- Remove the rear noise insulation by loosening the fasteners - 2 and 3 -

- Position the (V.A.G 1383 A) plunger with the (T10337) attached on the bottom of the transmission.






- Lift the transmission slightly using the (V.A.G 1383 A).


There is the risk of an accident.

• The (V.A.G 1383 A) may only be used during assembly and must not sit unsupervised under the vehicle.

- Remove the bolts from the tunnel crossmember - arrows -.






- Remove the nuts - arrow - and the tunnel crossmember.






Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Tunnel Crossmember, Transmission Mount and Transmission Support Overview ] Tunnel Crossmember, Transmission Mount and Transmission Support Overview.

- Install the noise insulation.