Bench Seat

Bench Seat





Removing

- Pull the bench seat, on the front edge, up and out of the left and right mounting grommets - 1 -.

- Disengage bench seat from mounting - 4 - on left and right, forcefully push bench seat backward to do so.

- On vehicles with seat heaters, lift bench seat far enough so that electrical harness connectors can be disconnected.

- Remove electrical harness connector for side airbag from groove. Refer to => [ Side airbag cable connector ].

- Remove the bench seat from vehicle.

Installation

Installation is performed in reverse order of removal, noting the following:

CAUTION!
The mounting grommets must be replaced each time the bench seat is removed. Refer to => [ Replacing mountings ].

Side airbag cable connector





CAUTION!
For vehicles with side airbags, observe safety precautions for side airbags. Refer to => [ Side Airbag Additional Safety Precautions ] Side Airbag Additional Safety Precautions.

Replacing mountings





- Remove used mounting from chassis cut-out.

- Insert the new mounting grommet - 2 - into the body opening until it engages - 1 -.