Left Vent Temperature Sensor

Left Vent Temperature Sensor

Removing

- Switch off ignition.

- Remove the driver side storage compartment.

- Remove the left lower center console cover.

- On the left side remove the holder for the instrument panel - A - and the screws - C -.





- Remove the air duct to the driver's footwell vent - B -.

• Depending on the vehicle equipment and the tolerance between the A/C unit and the holder for the pedal cluster, it may be necessary to loosen the pedal cluster from the vehicle and move it slightly to the left in order to remove the footwell vent - B - on the driver's side.

• In model year 2005, the footwell vent - B - air duct mount was changed (gradual introduction). The upper bolt - C - no longer has to be removed, the air duct clips in place via retaining tabs - A -.





- Mark connector - C - to the Left Vent Temperature Sensor (G150) (danger of interchange with other connectors of same construction).





- Disconnect connector - A - from the Left Vent Temperature Sensor (G150).

- Rotate the Left Vent Temperature Sensor (G150) - B - approximately 90° in direction of arrow.

- Remove the Left Vent Temperature Sensor (G150) - B - from the A/C unit.

Installing

Installation is carried out in the reverse order, when doing this note the following.

- Insert the Left Vent Temperature Sensor (G150) - B - on the proper side into A/C unit mount - D -.





- Check the Left Vent Temperature Sensor (G150) for correct seating in mount - D -.

• The Left Vent Temperature Sensor (G150) - B - can only be inserted into mount - D - in one position, rotate 180° if necessary).

• An O-ring seal - C - can be installed so that the Left Vent Temperature Sensor (G150) fits without play in mount - D -.

- Install the removed components again in reverse order.

- Check the DTC memory for the Climatronic Control Module (J255) A/C control head and erase any faults displayed if necessary.