Battery, Disconnecting and Connecting
Battery, Disconnecting and Connecting
Procedure
- Switch off ignition and remove ignition key.
Sedan:
- Lift and secure luggage compartment floor mat.
Avant:
- Remove luggage compartment storage area floor - 1 - and cover for spare wheel - 2 -.
All:
- Release battery strap - 1 - if present.
• If the battery strap does not have a quick-release, then remove the screw on the strap.
- Release retaining clips - arrows - using a screwdriver - 2 - and remove ground (GND) terminal cap - 1 -.
• Illustration shows molded insert removed.
- Loosen nut several turns and remove ground wire terminal clamp - arrow - from battery terminal.
Vehicles with Battery Monitoring Control Module (J367):
- Release the strap - arrow B - and open the cover over the battery negative terminal - arrow A - - 1 -.
- Disconnect the electrical connector - 1 - on the battery monitoring control module - 1 -.
All Vehicles
- To connect, connect terminal clamp of Ground (GND) wire by hand to battery negative terminal negative and tighten nut.
Vehicles with Battery Monitoring Control Module (J367):
- Connect the connector - 1 - on the battery monitoring control module - 2 -.
All Vehicles
When connecting the battery, perform the following steps:
• Activate the power window regulator one-touch up/down function.
• Synchronize the spare and additional keys to ensure remote control operation. To do so, insert key into ignition lock, switch the ignition on and off again and remove key.
• Check the DTC memories of all the control units and erase under voltage the fault if necessary.
• After connecting the power supply, the ABS warning lamp may only go out after the vehicle has been driven a few yards.
Tightening Specifications