Front Belt Latch

Front Belt Latch

Removing






- Adjust the front seat all the way back and up to the stop.

- Remove the front seat:

• Standard seat and Sport seat (manual), refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

• Standard seat, Sport seat (power) and Comfort seat, refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

• Super sport seat, refer to => [ Super Sport Front Seat ] Super Sport Front Seat.

- Disconnect harness connector - 2 - and free up electrical wire.

- Remove bolt - 3 - and remove belt latch - 1 -.

Installing






Install in reverse order of removal. Note the following:

- Replace the seat belt latch bolt.

Belt Latch Installation Position

- Position the seat belt latch - 2 - so the opening - arrow B - aligns with the tab - arrow A - on the seat frame - 1 -.

Seat Occupied Recognition for Passenger Airbag Deactivation:

- If the seat belt latch of the passenger occupant detection system for front passenger airbag deactivation is replaced, fill out the system registration sheet with the serial number and bar code label from the new seat belt latch and send it to the importer.

All Vehicles:

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground (GND) cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the vehicle diagnostic tester.

For the correct tightening specifications, refer to => [ Front Belt Anchor Overview ] Front Belt Anchor Overview.