Left Front Coolant Pipes

Left Front Coolant Pipes

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm Dia. (3094)

• Drip Tray (VAS 6208)

• Hose Clip Pliers (VAS 6362)

Removing

- Remove the front engine cover - 1 - upward.






- Remove the noise insulation, to do this loosen the fasteners - 1, 2, arrow -.







Risk of scalding due to hot steam and hot coolant.

• The coolant system is under pressure when the engine is warm.

• Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure in the system.

Risk of injury from coolant fan starting by itself.

• The radiator fan can come on even when the ignition is turned off, for example, caused by the heat still in the engine compartment.

- Open the coolant reservoir cap.

- Place the (VAS 6208) under engine.

- Open the clamps - arrows - and disconnect the coolant hoses with the (3094) and remove them from the left front coolant pipes.






- Remove the bolt - 1 -.

• The installation location is shown with the lock carrier removed.

- Remove the coolant hoses, to do this, loosen the hose clamps - arrows -.






- Remove the bolt - 1 -.

- Remove the left front coolant pipes downward.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Coolant Pipes Overview ] Coolant Pipes Overview.

• Secure all hose connections with hose clamps appropriate for the model.

- Fill with coolant => [ Filling ] Procedures.

- Install the noise insulation.