Voltage Regulator, Valeo Generator from 2007
Voltage Regulator, Valeo Generator from 2007
Special tools, testers and auxiliary items required
• Feeler Gauge 0.3 mm
Removing
- Remove the generator.
- Press out the cover - arrows - from the threaded pins on the rear of the generator.
- Remove the bolts - 1 - and stud bolt - 2 -.
- Remove the voltage regulator.
Installing
- Insert a feeler gauge - 4 - between the protective cap - 2 - and carbon brushes - 3 -.
- Pull the protective cap off until the bar of the protective cap presses the carbon brushes down.
- After installation of the voltage regulator, press the protective cap all the way on.
Install in reverse order of removal, observing the following:
- Install the generator.
• Tightening specifications, refer to => [ Valeo Generator Overview, from 2001 ] Valeo Generator Overview, from 2001.