Front Seat Backrest Stop Switches E69 and E70

Front Seat Backrest Stop Switches E69 and E70

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the backrest. Refer to => [ Front Backrest ] Front Backrest.

- Remove backrest cover panel. Refer to => [ Backrest Cover ] Backrest Cover.

- Disconnect connector - 1 - from coupling - 2 -.






- Remove coupling - 2 - upward from mount on housing - 3 -.

- Clip on housing cover - 3 -.






- Remove driver backrest stop switch (E69) or front passenger backrest stop switch (E70) - 2 - with wire and coupling from housing - 1 -.

• The two stop switches in the housing must not be separated and can only be replaced together with wire and coupling.

Installation

Install in reverse order of removal. Note the following:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

• Make sure the connectors are installed all the way in and are secure.

- Switch on ignition.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect battery ground cable with ignition switched on.

- If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.