Seat Angle Adjustment Motor

Seat Angle Adjustment Motor

Removing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Remove the front seat:

• Standard and sport power seat, comfort seat and super sport seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Attach the front seat to the (VAS 6136) => [ Front Seats, Installing on the ] Front Seats, Installing on the Fixture For Seat Repair (VAS 6136).

- Disconnect electrical harness connector - 3 - on seat angle adjustment motor - 4 -.






- Remove the bolt - 2 - for the adjustment spindle - 5 - (preset by the manufacturer).

- Do not damage the bushing - 1 - inserted in the bearing area - 2 - when removing the bolt.






• The bushings cannot be replaced with workshop materials.

• If the bushings are damaged, replace the corresponding components.

- Remove the bolts - 1 -.






- Remove the seat angle adjustment motor from the front seat.

Installing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Clean the threaded bolt holes for self-locking nuts, for example using a thread tap.

- Replace all self-locking bolts.

- Do not damage bushing - 1 - when inserting the bolt.






• The bushings cannot be replaced with workshop materials.

• If the bushings are damaged, replace the corresponding components.

Installation is performed in reverse order of removal, noting the following:

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.